1. Wash and dry your hands.
2. Apply enough product to thoroughly moisten a clean cotton pad.
3. Press the pad gently against the skin for several seconds to help loosen makeup, sunscreen and residue.
4. Wipe softly across the face and neck without repeated rubbing or stretching the skin.
5. Repeat with fresh pads until the final pad appears clean.
6. Rinse with lukewarm water if desired or if residue remains, then pat dry.
7. Continue with your chosen mist, serum, moisturiser and, every morning, broad-spectrum sunscreen.

Do not spray or pour directly into the eyes. Unless the finished-product label specifically confirms eye-area suitability, avoid using it on the eyelids or to remove eye makeup.

Morning

BioFerma‑Q10 Micellar Water™ → Rinse if desired → BioFerma‑Q10 SkinMist™ or Serum™ if used → AquaLock™ or moisturiser if required → Sunscreen

Evening

BioFerma‑Q10 Micellar Water™ → Rinse if desired → BioFerma‑Q10 leave-on product or Q‑Retinol Pro™ if used → AquaLock™ or moisturiser if required

For heavy, waterproof or long-wear makeup and water-resistant sunscreen, first use a suitable dedicated remover, then follow with this Micellar Water or a gentle rinse-off cleanser.

Use enough product to wet the cotton pad thoroughly without making it drip. A pad that is too dry creates unnecessary friction and may not lift residue effectively.

Press before wiping, work in gentle outward motions and use a fresh pad when the first becomes soiled. Do not scrub repeatedly over one area. The number of pads required will depend on the amount and type of makeup, sunscreen and surface residue present.

BioFerma‑Q10 Micellar Water™ is a wipe-off cleansing product used at the beginning of the routine. BioFerma‑Q10 SkinMist™ is a lighter leave-on spray, while BioFerma‑Q10 Probiotic Renewal Serum™ is the full-strength, more concentrated leave-on format.

The Micellar Water does not replace the leave-on formats because its primary purpose is cleansing and much of it is removed on the cotton pad or during rinsing. After cleansing, choose the leave-on product that best suits your skin and routine; using both SkinMist and Serum is not normally necessary.

The product is intended for everyday impurities, light makeup and sunscreen. Long-wear foundation, waterproof eye makeup and highly water-resistant sunscreen may require a dedicated remover or double-cleansing routine.

Avoid direct contact with the eyes. Unless the packaging specifically states that the finished product has been assessed for eye-area use, avoid the eyelids and use a dedicated eye-makeup remover. If accidental contact occurs, rinse thoroughly with clean water.

After use, skin should feel clean and refreshed rather than heavily coated. If makeup remains, use a more thoroughly saturated pad, allow a longer press time before wiping, or use a dedicated remover for resistant products.

If skin feels sticky or residue remains, rinse with lukewarm water. If skin feels tight, avoid over-cleansing and follow with a suitable leave-on hydrator or moisturiser. If stinging, redness, swelling or persistent discomfort develops, rinse thoroughly and stop use.

• For external use only.
• Avoid direct contact with the eyes and do not ingest.
• Do not apply to broken, irritated or inflamed skin.
• Do not share used cotton pads or return dispensed product to the container.
• Discontinue use and rinse thoroughly if persistent irritation occurs.
• Keep out of reach of children.
• Store away from excessive heat and direct light.
• Follow the directions and precautions printed on the packaging.

Patch test

Before first use, apply a small amount behind the ear or along the jawline with a clean cotton pad. Rinse or leave as directed on the final packaging and observe for 24–48 hours. Do not proceed if marked redness, swelling, itching or persistent discomfort develops. A patch test cannot guarantee that irritation will not occur during continued use.

Can I use it every day?

Yes. It is designed for regular morning or evening cleansing. Adjust frequency if your skin becomes dry, tight or uncomfortable.

Do I have to rinse it off?

You may follow the final no-rinse directions on the packaging, but rinsing is sensible for sensitive skin, after heavier makeup or sunscreen, or whenever residue remains.

Can it remove waterproof makeup?

It is intended for light everyday makeup and sunscreen. Waterproof and long-wear products may require a dedicated remover.

Does it contain live probiotics?

The formula uses ferment-derived cosmetic ingredients. “Probiotic” in the name describes the formulation concept and does not necessarily mean that live microorganisms are present in the finished preserved product.

Does it replace the BioFerma‑Q10 SkinMist™ or Serum™?

No. Micellar Water™ is used to cleanse and is wiped or rinsed away. The SkinMist and Serum are leave-on formats used after cleansing.

Can I use it before Q‑Retinol Pro™?

Yes. Cleanse first, rinse if desired, allow skin to dry and then apply Q‑Retinol Pro™ according to its Product Guide.

Keep tightly closed in a cool, dry place away from direct sunlight and excessive heat. Do not leave the product in a hot vehicle or near a window. Avoid touching the bottle opening with used cotton pads. Use within the period shown by the packaging symbol after opening.

Product: BioFerma‑Q10 Probiotic Renewal Micellar Water™
Category: Micellar facial cleanser
Country of manufacture: Singapore
Responsible company: Micellar Cosmetics Pte Ltd
Batch identification: Refer to the product container

Aqua, Coco Glucoside, Galactomyces Ferment Filtrate, Glyceryl Caprylate, Isoamyl Laurate, Saccharomyces Ferment, Lactobacillus Ferment, Squalane, Propanediol, Gluconolactone, Sodium Lactate, Sodium Ascorbyl Phosphate (SAP), Alpha-glucan Oligosaccharide, Sodium PCA, Niacinamide, Creatine, Trehalose, Natural Mixed Tocotrienols, Coenzyme Q10, Beta-Glucan, Lactic Acid, Sodium Phytate, Aloe Barbadensis (Aloe vera) Leaf Juice, Ferulic Acid, Camellia Sinensis (Green Tea) Leaf Extract, Quercetin, Resveratrol

BioFerma‑Q10 Probiotic Renewal Micellar Water™ uses the BioFerma‑Q10 SkinMist™ ingredient system in a further diluted cleansing format. The ingredient declaration and order must match the final Micellar Water packaging for the applicable product batch.